International DT466 ENGINE SYSTEMS Engine Component Locations

Dt466 Injector Driver Module Location. Dt466 Engine Wiring Diagram » Wiring Diagram And Schematics The function diagram for the IDM PWR includes the following: • IDM • IDM main power relay • Ignition switch or power relay • Battery • Fuses Function The Injector Drive Module (IDM) requires a 12 V power source The function diagram for INJ circuit includes the following: • Injectors • Electronic Control Module (ECM) • Injector Driver Module (IDM) • Controller Area Network (CAN 1) link • Camshaft Position Output (CMPO) signal • Crankshaft Position Output (CKPO) signal Function The IDM is used to control the injectors.

4300 with DT466 that has what I expected to be a failing Injection driver module I have narrowed it down to the IDM Relay I have constant 12v to all the prongs with the relay plugged in

International Dt466 Engine Fuel Injector Diagram

Remove and replace IDM relayReplace injector driver module. The IDM receives injector diagnostic commands, operation strategies, modes and conditions from the ECM The operating power is received from the vehicle batteries through the IDM main power relay contacts each time the ignition switch is turned ON

20052008 International 4300 Diesel Injector Driver Module. Customer: where is the IDM on a International 4700 with a DT466e The IDM receives injector diagnostic commands, operation strategies, modes and conditions from the ECM

Dt466 Engine Diagram General Wiring Diagram. The function diagram for INJ circuit includes the following: • Injectors • Electronic Control Module (ECM) • Injector Driver Module (IDM) • Controller Area Network (CAN 1) link • Camshaft Position Output (CMPO) signal • Crankshaft Position Output (CKPO) signal Function The IDM is used to control the injectors. I replaced the relay still getting 12v to pin 85 which says I should not be getting that with key on